XCAP Control Panel for the Mikrotron MC1310 with the PIXCI® miniH2x4F

XCAP software software provides easy to use controls for the Mikrotron MC1310 camera as supported by the PIXCI® miniH2x4F frame grabber using the M.2 x4 Gen 2 bus/interface. After following the camera manufacturer's directions to configure the camera, these controls allow easy configuration of the frame grabber to match!

(XCAP Control Panel for the Mikrotron MC1310)

Try these controls: Download, install, and run XCAP. Click PIXCI®, PIXCI® Camera Info. Click under 'Adjust Dialog' to launch interactive controls for this or any other supported camera.

Back to the PIXCI Selection Guide