XCAP Control Panel for the Andor Zyla 5.5 12 bit with the PIXCI® mf2280

XCAP software software provides easy to use controls for the Andor Zyla 5.5 12 bit camera as supported by the PIXCI® mf2280 frame grabber using the M.2 x4 Gen 2 bus/interface. After following the camera manufacturer's directions to configure the camera, these controls allow easy configuration of the frame grabber to match!

(XCAP Control Panel for the Andor Zyla 5.5 12 bit)

Try these controls: Download, install, and run XCAP. Click PIXCI®, PIXCI® Camera Info. Click under 'Adjust Dialog' to launch interactive controls for this or any other supported camera.

Back to the PIXCI Selection Guide