XCAP Control Panel for the IDT M-3 Mono with the PIXCI® E8

XCAP software software provides easy to use controls for the IDT M-3 Mono camera as supported by the PIXCI® E8 frame grabber using the PCI Express x8 bus. After following the camera manufacturer's directions to configure the camera, these controls allow easy configuration of the frame grabber to match!

(XCAP Control Panel for the IDT M-3 Mono)

Try these controls: Download, install, and run XCAP. Click PIXCI®, PIXCI® Camera Info. Click under 'Adjust Dialog' to launch interactive controls for this or any other supported camera.

Back to the PIXCI Selection Guide