XCAP Control Panel for the IDT M-3 Mono with the PIXCI® E4(Rev7+)

XCAP software software provides easy to use controls for the IDT M-3 Mono camera as supported by the PIXCI® E4(Rev7+) frame grabber using the PCI Express x4 Gen 2 bus. After following the camera manufacturer's directions to configure the camera, these controls allow easy configuration of the frame grabber to match!

(XCAP Control Panel for the IDT M-3 Mono)

Try these controls: Download, install, and run XCAP. Click PIXCI®, PIXCI® Camera Info. Click under 'Adjust Dialog' to launch interactive controls for this or any other supported camera.

Back to the PIXCI Selection Guide